If perhaps the water coming from the faucets at home doesn’t smell good, there might be an issue with your hot water heater. There might be multiple various causes of stinky water, yet the main cause is bacteria. In the event that bacteria is getting in the water, an odor is likely to appear. Well water is often to blame for this taking place. Even so, there are a few actions a Roswell GA homeowner can take to prevent bacteria from expanding in their water and to get rid of current bacteria and odors.

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Protecting Against Water Heater Bacteria Growth

The most effective way to prevent bacteria from growing and resulting in awful tastes and smells in one’s house, is to make sure the temperature is set at 140 degrees or higher on one’s hot water heater. In this temp bacteria can’t grow and will die. If your water heater temp is placed below this, bacteria will not only survive but can multiply.

Eliminating Hot Water Heater BacteriaRoswell Water Heater Odors

To remove active bacteria and smells, one must use chemicals to eliminate it. Chlorine bleach is the most powerful and complete chemical cleaner to use. In case you are trying to clean the water and get rid of the bacteria applying bleach yourself, be sure to have an understanding of the complete way of doing this. First of all, the electric or gas going to the water heater must be turned off. After that the cold water supply will have to be turned off. Then, you must turn on one of the hot water taps within the house. This lets air into the tank. Using a garden hose, drain the water out of the hot water heater and close up the drain valve once all of the water has been drained. After this, it’s time to pour in the bleach. One will be needing five oz of chlorine bleach for every gallon of water the tank retains. Remove the flexible cold water hose and pour the bleach in the opening. In the event that the cold water hose is not flexible, it could be a wise decision to get in touch with a specialist. Hook up the water line again and fill up the tank with water. It’s necessary to shut the hot water tap in the home when all the air is out of the line. It is likewise vital to run each one of the faucets which employ hot water in the home until you’re able to smell the bleach. The bacteria which is in the water heater can also be in water lines and faucets therefore you will have to get rid of the bacteria in those locations also. Allow the bleach water sit inside the tank and inside the water lines for around 3 hours not having utilizing any hot water. After that yet another flush is in order. After the tank is drained for a second time, do not put in more bleach but fill up with water and allow it to remain in the tank and inside the pipes for a minimum of thirty minutes. Finally, drain the water once more and then replenish the tank with water. Let all the hot water fixtures in the house run until you can not smell bleach. Either flip the power back on or reignite the pilot light and you should be all set!

For any concerns about water smell, flushing a water heater, Roswell water heater repairs, or other water heater problems, give us a call!